2000 Toyota Sienna Door Handle Removal

Be sure to unhook the cable used to open the door from the broken handle before trying to remove the handle 11.

2000 toyota sienna door handle removal.

Remove the phillips screw that holds the door handle trim piece under the door handle remove the phillips screw at the upper front under the small round trim cap. Step 1 remove the door panels. Maybe you could locate the parts second hand. Alldata may be most helpful for removal instructions.

The failure mileage was approximately 70 000. 2000 toyota sienna broken power door cable. Remove the arm rest by forcing it up with a screw driver. This video contains a detailed description of how to remove a 2000 toyota sienna door panel.

Pry gently around all sides of. We have the best products at the right price. Unscrew them with everything else done and the broken handle falls off. Used your guide and the replacement took about 20 minutes.

Start with the end towards the front of the car. When trying to locate or find second hand parts the best way post a request to many wrecking yards at the same time is to google the words wrecking yard parts or used. There are two small phillips screws holding the broken handle in place. Pry gently around all sides of the cap prying a little more each time.

Reverse the steps it all goes back togethe pretty easily. The rear hatch could not be opened from the outside or the inside. To replace the door handle on a toyota sienna van is not so hard to do just time consuming. The contact stated that the outside door handles were falling off the vehicle.

Broken power door cable. The contact had to remove the driver side door driver side sliding door and rear hatch door handles. I had done most of the work already but i go into detail what t. Remove the phillips screw that holds the door handle trim piece under the door handle remove the phillips screw at the upper front under the small round trim cap.